Other Archive - Jokon https://www.jokon.de/en/produkt-kategorie/other/ Thu, 13 Oct 2022 08:01:00 +0000 en-GB hourly 1 https://wordpress.org/?v=6.5 https://www.jokon.de/wp-content/uploads/2021/03/cropped-Favicon-1-32x32.jpg Other Archive - Jokon https://www.jokon.de/en/produkt-kategorie/other/ 32 32 shopengine_activated_templates a:0:{} Interior light https://www.jokon.de/en/produkt/interior-light/ Wed, 27 Oct 2021 13:28:31 +0000 https://www.jokon.de/?post_type=product&p=9352 Read More  

Der Beitrag Interior light erschien zuerst auf Jokon.

]]> Der Beitrag Interior light erschien zuerst auf Jokon.

]]> Control Device LK 100-x https://www.jokon.de/en/produkt/control-device-lk-100-x/ Fri, 24 Sep 2021 09:01:21 +0000 https://www.jokon.de/?post_type=product&p=8116 Function: if the LED light is o.k. and it complies with the ECE regulation, the LK 100 switches on a high power resistor (in parallel to the LED light). In case of a LED
defect (or values below ECE regulation), the high power resistor will be switched off and the DI relais recognizes the failure because of the missing power.

Read More  

Der Beitrag Control Device LK 100-x erschien zuerst auf Jokon.

]]> – LED failure control for left and right DI light
– may be used only in combination with „warm check“
– incl. 2 high power resistors (simul. of 21W-incand. lamp)
– aluminium housing / completely sealed electronics
– for fixation on even, metallic surfaces
– incl. 2 cables (1.5m) for left/right light (4×0.75mm²)
– ON 100% (flashing operation), IP 67
– automatic overtemperature protection
.- 32 x 91 x 131 mm

– important notice:

(1) all newly developed LED lights (incl. „LDC“ ->
LED-Defect-Control) can be used with LK 100b-1. For old light models
special versions of LK 100 are required (LK 100-2 / -3…)
(2) installation manual must be respected!

Der Beitrag Control Device LK 100-x erschien zuerst auf Jokon.

]]> Control Device LS 200 https://www.jokon.de/en/produkt/control-device-ls-200-2/ Fri, 24 Sep 2021 08:56:31 +0000 https://www.jokon.de/?post_type=product&p=8109 LED lights have significantly less power consumption than bulb lights and behave completely differently from an electronic point of view. The on-board computers of most vehicles are designed to work with trailers equipped with bulb lights. Consequently, various problems may occur when using LED lights and traffic safety is no longer ensured! An additional device is required depending on the light functions to make the lights compatible with towing vehicles. The LK 200 ensures the correct monitoring of direction indicator lights according to ECE-R48. The LS 200 simulates parallel to the LED light a load for one function comparable to that of bulbs for other light functions (stop, tail, fog and reversing light).

Read More  

Der Beitrag Control Device LS 200 erschien zuerst auf Jokon.

]]> LS 200
– resistor simulation for all other LED light functions
– incl. power resistor for one function: ST 2x20W, TL 2x10W,
FL/RV each 1 x 20W

All devices:
– aluminium housing / completely sealed electronics
– for fixation on even, metallic surfaces with 4 x M5 or alternatively 4 x ST 4,2
– incl. 2 cables ( 1,5m ) for left / right light ( 4×0.75mm² )
– automatic overtemperature protection
– 169 x 96 x 37 mm

important notice:
(1) the unit is compatible with almost all vehicles – nevertheless
the compatibility with the used car must be exactly proved before setting
out on the first journey!
(2) the product can only be used in conjunction with newly developed JOKON LED lights with “LDC” (-> LED defect control) used will!

(3)installation manual must be respected carefully!
(4) delivery on request

Der Beitrag Control Device LS 200 erschien zuerst auf Jokon.

]]> Control Device LK 2000-1 https://www.jokon.de/en/produkt/control-device-lk-2000-1/ Fri, 24 Sep 2021 08:49:27 +0000 https://www.jokon.de/?post_type=product&p=8104 LED lights have a significant lower power than bulb lamps and behave electronically completely different. The on-board computers of most vehicles are designed to work with trailes which are equipped with bulb lights. As a result there might be various problems. The traffic safety is not ensured any more! To make trailers with LED lights compatible with towing vehicles, an additional device is required (LK2000). This device ensures the correct monitoring of direction indicator light according to ECE-R48 also in case of LED lights and simulates for all other light functions (stop, tail, fog, reversing light) a load comparable with bulb lights.

Read More  

Der Beitrag Control Device LK 2000-1 erschien zuerst auf Jokon.

]]> – failure control and resistor simulation for LED direction indicator lights
as well as resistor simulation for all other LED light functions
– the product monitors both tail lights: left and right side
– for use with vehicles with common commercially available
direction indicator monitoring according to the following systems:
warm check, cold check and combination thereof
– incl. power resistor: DI 2x20W, ST 2x20W, TL 2x10W, FL/RV each 20W
– aluminium housing / completely sealed electronics
– for fixation on even, metallic surfaces with
4 x M6 or 2 x M8 or alternatively with metal clamps
– harness: 7 x 1,5mm² + 1 x 2,5mm² – IN 1 x 3,5m – OUT 1 x 1,5m
– automatic overtemperature protection
– 289 x 100 x 50 mm

– important notice:
(1) the unit is compatible with almost all vehicles – nevertheless
the compatibility with the used car must be exactly proved before setting
out on the first journey!
(2) the unit can be used only with newly developed JOKON-LED-lights
with „LDC“ (->LED-Defect-Control)!
(3) installation manual must be respected carefully!
(4) delivery on request

Der Beitrag Control Device LK 2000-1 erschien zuerst auf Jokon.

]]> Awning / Prefield Light WW 250 https://www.jokon.de/en/produkt/awning-prefield-light-ww-250/ Thu, 23 Sep 2021 14:11:24 +0000 https://www.jokon.de/?post_type=product&p=7890 The LED Awning / Prefield Lights WW 250 offer more than just brightness: they appeal by an exclusive and elegant design which is still pleasantly descreet. The light distribution is extremely even owing to a rotationally symmetrical optical system, so that nothing remains in the „dark“.

Read More  

Der Beitrag Awning / Prefield Light WW 250 erschien zuerst auf Jokon.

]]> – LED awning / prefield light with 12 white high-power LED‘s
– luminous flux approx. 250 Lumen (approx. 35W GU10 halogen bulb)
– beam angle ahead: 0…90° / lateral -45…+45°
– designed for surface mounting
– installation from rear (M5 screw) or front (ST 4,2)

Der Beitrag Awning / Prefield Light WW 250 erschien zuerst auf Jokon.

]]> Reversing Light W 2011-2 https://www.jokon.de/en/produkt/reversing-light-w-2011-2/ Thu, 23 Sep 2021 10:47:37 +0000 https://www.jokon.de/?post_type=product&p=7680 The LED Reversing Light W 2011-2 convince with a very compact design. Two high power LED assure an optimal light output - in combination with a high efficiency switching
circuit and a metal core PCB.

Read More  

Der Beitrag Reversing Light W 2011-2 erschien zuerst auf Jokon.

]]> – LED reversing light with 2 white high-power LEDs
– 2 lights (in pairs) (l/h + r/h) mandatory
– designed for vertical surface mounting
– with chrome-plated design part
– installation from rear (M4 screw) or front (ST3.5)
– incl. non visible membrane for thermodynamic balance
– incl. accessory: EPDM gasket 1 mm / ST3.5-screws (stainl.)

-PMMA lens, bottom ABS / PC light grey

– incl. 300 mm ADR sheathed cable 2 x 1.0 mm² / 6.3 mm blade terminals

Der Beitrag Reversing Light W 2011-2 erschien zuerst auf Jokon.

]]> Number Plate Light K 580b https://www.jokon.de/en/produkt/number-plate-light-k-580b/ Thu, 23 Sep 2021 10:30:55 +0000 https://www.jokon.de/?post_type=product&p=7636 The LED Number Plate Light K 580b with 200 mm connection cable for flush-fitting, variable mounting positions.

Read More  

Der Beitrag Number Plate Light K 580b erschien zuerst auf Jokon.

]]> – flush fitting
– waterproof sealed

Der Beitrag Number Plate Light K 580b erschien zuerst auf Jokon.

]]>